Go to: Message List•New Topic•Search
Re: Steel shop tool question
Author: Shortline Sammie
Date: 10-02-2020 - 12:28

You are correct in that the bottom die is stationary and the stroke of the press is pre-set to end up with the proper curvature.

Since multiple pieces are riveted together the holes need to be in precision alignment but the fit-up of the various pieces will be brought into contact once the rivets are driven. Often times bolts will be placed in a few selected locations and once the surrounding rivets are tensioned the bolts are cut off and replaced by permanent rivets.

Navigate: Previous Message•Next Message
Options: Reply To This Message•Quote This Message


Subject Written By Date/Time (PST)
  Steel shop tool question I am full of questions 10-02-2020 - 11:29
  Re: Steel shop tool question Shortline Sammie 10-02-2020 - 12:28


Go to: Message List•Search
Subject: 
Your Name: 
Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically.
 **    **  **     **   ******    *******   **    ** 
 **   **    **   **   **    **  **     **  **   **  
 **  **      ** **    **        **         **  **   
 *****        ***     **        ********   *****    
 **  **      ** **    **        **     **  **  **   
 **   **    **   **   **    **  **     **  **   **  
 **    **  **     **   ******    *******   **    **
This message board is maintained by:Altamont Press
You can send us an email at altamontpress1@gmail.com